| // SPDX-License-Identifier: GPL-2.0-or-later | |
| /* | |
| * The Netronix embedded controller is a microcontroller found in some | |
| * e-book readers designed by the original design manufacturer Netronix, Inc. | |
| * It contains RTC, battery monitoring, system power management, and PWM | |
| * functionality. | |
| * | |
| * This driver implements register access, version detection, and system | |
| * power-off/reset. | |
| * | |
| * Copyright 2020 Jonathan Neuschäfer <j.neuschaefer@gmx.net> | |
| */ | |
| #include <linux/delay.h> | |
| #include <linux/errno.h> | |
| #include <linux/i2c.h> | |
| #include <linux/mfd/core.h> | |
| #include <linux/mfd/ntxec.h> | |
| #include <linux/module.h> | |
| #include <linux/pm.h> | |
| #include <linux/reboot.h> | |
| #include <linux/regmap.h> | |
| #include <linux/types.h> | |
| #include <linux/unaligned.h> | |
| #define NTXEC_REG_VERSION 0x00 | |
| #define NTXEC_REG_POWEROFF 0x50 | |
| #define NTXEC_REG_POWERKEEP 0x70 | |
| #define NTXEC_REG_RESET 0x90 | |
| #define NTXEC_POWEROFF_VALUE 0x0100 | |
| #define NTXEC_POWERKEEP_VALUE 0x0800 | |
| #define NTXEC_RESET_VALUE 0xff00 | |
| static struct i2c_client *poweroff_restart_client; | |
| static void ntxec_poweroff(void) | |
| { | |
| int res; | |
| u8 buf[3] = { NTXEC_REG_POWEROFF }; | |
| struct i2c_msg msgs[] = { | |
| { | |
| .addr = poweroff_restart_client->addr, | |
| .flags = 0, | |
| .len = sizeof(buf), | |
| .buf = buf, | |
| }, | |
| }; | |
| put_unaligned_be16(NTXEC_POWEROFF_VALUE, buf + 1); | |
| res = i2c_transfer(poweroff_restart_client->adapter, msgs, ARRAY_SIZE(msgs)); | |
| if (res < 0) | |
| dev_warn(&poweroff_restart_client->dev, | |
| "Failed to power off (err = %d)\n", res); | |
| /* | |
| * The time from the register write until the host CPU is powered off | |
| * has been observed to be about 2.5 to 3 seconds. Sleep long enough to | |
| * safely avoid returning from the poweroff handler. | |
| */ | |
| msleep(5000); | |
| } | |
| static int ntxec_restart(struct notifier_block *nb, | |
| unsigned long action, void *data) | |
| { | |
| int res; | |
| u8 buf[3] = { NTXEC_REG_RESET }; | |
| /* | |
| * NOTE: The lower half of the reset value is not sent, because sending | |
| * it causes an I2C error. (The reset handler in the downstream driver | |
| * does send the full two-byte value, but doesn't check the result). | |
| */ | |
| struct i2c_msg msgs[] = { | |
| { | |
| .addr = poweroff_restart_client->addr, | |
| .flags = 0, | |
| .len = sizeof(buf) - 1, | |
| .buf = buf, | |
| }, | |
| }; | |
| put_unaligned_be16(NTXEC_RESET_VALUE, buf + 1); | |
| res = i2c_transfer(poweroff_restart_client->adapter, msgs, ARRAY_SIZE(msgs)); | |
| if (res < 0) | |
| dev_warn(&poweroff_restart_client->dev, | |
| "Failed to restart (err = %d)\n", res); | |
| return NOTIFY_DONE; | |
| } | |
| static struct notifier_block ntxec_restart_handler = { | |
| .notifier_call = ntxec_restart, | |
| .priority = 128, | |
| }; | |
| static int regmap_ignore_write(void *context, | |
| unsigned int reg, unsigned int val) | |
| { | |
| struct regmap *regmap = context; | |
| regmap_write(regmap, reg, val); | |
| return 0; | |
| } | |
| static int regmap_wrap_read(void *context, unsigned int reg, | |
| unsigned int *val) | |
| { | |
| struct regmap *regmap = context; | |
| return regmap_read(regmap, reg, val); | |
| } | |
| /* | |
| * Some firmware versions do not ack written data, add a wrapper. It | |
| * is used to stack another regmap on top. | |
| */ | |
| static const struct regmap_config regmap_config_noack = { | |
| .name = "ntxec_noack", | |
| .reg_bits = 8, | |
| .val_bits = 16, | |
| .cache_type = REGCACHE_NONE, | |
| .reg_write = regmap_ignore_write, | |
| .reg_read = regmap_wrap_read | |
| }; | |
| static const struct regmap_config regmap_config = { | |
| .name = "ntxec", | |
| .reg_bits = 8, | |
| .val_bits = 16, | |
| .cache_type = REGCACHE_NONE, | |
| .val_format_endian = REGMAP_ENDIAN_BIG, | |
| }; | |
| static const struct mfd_cell ntxec_subdev[] = { | |
| { .name = "ntxec-rtc" }, | |
| { .name = "ntxec-pwm" }, | |
| }; | |
| static const struct mfd_cell ntxec_subdev_pwm[] = { | |
| { .name = "ntxec-pwm" }, | |
| }; | |
| static int ntxec_probe(struct i2c_client *client) | |
| { | |
| struct ntxec *ec; | |
| unsigned int version; | |
| int res; | |
| const struct mfd_cell *subdevs; | |
| size_t n_subdevs; | |
| ec = devm_kmalloc(&client->dev, sizeof(*ec), GFP_KERNEL); | |
| if (!ec) | |
| return -ENOMEM; | |
| ec->dev = &client->dev; | |
| ec->regmap = devm_regmap_init_i2c(client, ®map_config); | |
| if (IS_ERR(ec->regmap)) { | |
| dev_err(ec->dev, "Failed to set up regmap for device\n"); | |
| return PTR_ERR(ec->regmap); | |
| } | |
| /* Determine the firmware version */ | |
| res = regmap_read(ec->regmap, NTXEC_REG_VERSION, &version); | |
| if (res < 0) { | |
| dev_err(ec->dev, "Failed to read firmware version number\n"); | |
| return res; | |
| } | |
| /* Bail out if we encounter an unknown firmware version */ | |
| switch (version) { | |
| case NTXEC_VERSION_KOBO_AURA: | |
| case NTXEC_VERSION_TOLINO_VISION: | |
| subdevs = ntxec_subdev; | |
| n_subdevs = ARRAY_SIZE(ntxec_subdev); | |
| break; | |
| case NTXEC_VERSION_TOLINO_SHINE2: | |
| subdevs = ntxec_subdev_pwm; | |
| n_subdevs = ARRAY_SIZE(ntxec_subdev_pwm); | |
| /* Another regmap stacked on top of the other */ | |
| ec->regmap = devm_regmap_init(ec->dev, NULL, | |
| ec->regmap, | |
| ®map_config_noack); | |
| if (IS_ERR(ec->regmap)) | |
| return PTR_ERR(ec->regmap); | |
| break; | |
| default: | |
| dev_err(ec->dev, | |
| "Netronix embedded controller version %04x is not supported.\n", | |
| version); | |
| return -ENODEV; | |
| } | |
| dev_info(ec->dev, | |
| "Netronix embedded controller version %04x detected.\n", version); | |
| if (of_device_is_system_power_controller(ec->dev->of_node)) { | |
| /* | |
| * Set the 'powerkeep' bit. This is necessary on some boards | |
| * in order to keep the system running. | |
| */ | |
| res = regmap_write(ec->regmap, NTXEC_REG_POWERKEEP, | |
| NTXEC_POWERKEEP_VALUE); | |
| if (res < 0) | |
| return res; | |
| if (poweroff_restart_client) | |
| /* | |
| * Another instance of the driver already took | |
| * poweroff/restart duties. | |
| */ | |
| dev_err(ec->dev, "poweroff_restart_client already assigned\n"); | |
| else | |
| poweroff_restart_client = client; | |
| if (pm_power_off) | |
| /* Another driver already registered a poweroff handler. */ | |
| dev_err(ec->dev, "pm_power_off already assigned\n"); | |
| else | |
| pm_power_off = ntxec_poweroff; | |
| res = register_restart_handler(&ntxec_restart_handler); | |
| if (res) | |
| dev_err(ec->dev, | |
| "Failed to register restart handler: %d\n", res); | |
| } | |
| i2c_set_clientdata(client, ec); | |
| res = devm_mfd_add_devices(ec->dev, PLATFORM_DEVID_NONE, | |
| subdevs, n_subdevs, NULL, 0, NULL); | |
| if (res) | |
| dev_err(ec->dev, "Failed to add subdevices: %d\n", res); | |
| return res; | |
| } | |
| static void ntxec_remove(struct i2c_client *client) | |
| { | |
| if (client == poweroff_restart_client) { | |
| poweroff_restart_client = NULL; | |
| pm_power_off = NULL; | |
| unregister_restart_handler(&ntxec_restart_handler); | |
| } | |
| } | |
| static const struct of_device_id of_ntxec_match_table[] = { | |
| { .compatible = "netronix,ntxec", }, | |
| {} | |
| }; | |
| MODULE_DEVICE_TABLE(of, of_ntxec_match_table); | |
| static struct i2c_driver ntxec_driver = { | |
| .driver = { | |
| .name = "ntxec", | |
| .of_match_table = of_ntxec_match_table, | |
| }, | |
| .probe = ntxec_probe, | |
| .remove = ntxec_remove, | |
| }; | |
| module_i2c_driver(ntxec_driver); | |
| MODULE_AUTHOR("Jonathan Neuschäfer <j.neuschaefer@gmx.net>"); | |
| MODULE_DESCRIPTION("Core driver for Netronix EC"); | |
| MODULE_LICENSE("GPL"); |