| # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/input/touchscreen/apple,z2-multitouch.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Apple touchscreens attached using the Z2 protocol |
| |
| maintainers: |
| - Sasha Finkelstein <fnkl.kernel@gmail.com> |
| |
| description: A series of touschscreen controllers used in Apple products |
| |
| allOf: |
| - $ref: touchscreen.yaml# |
| - $ref: /schemas/spi/spi-peripheral-props.yaml# |
| |
| properties: |
| compatible: |
| enum: |
| - apple,j293-touchbar |
| - apple,j493-touchbar |
| |
| interrupts: |
| maxItems: 1 |
| |
| reset-gpios: |
| maxItems: 1 |
| |
| firmware-name: |
| maxItems: 1 |
| |
| apple,z2-cal-blob: |
| $ref: /schemas/types.yaml#/definitions/uint8-array |
| maxItems: 4096 |
| description: |
| Calibration blob supplied by the bootloader |
| |
| required: |
| - compatible |
| - interrupts |
| - reset-gpios |
| - firmware-name |
| - touchscreen-size-x |
| - touchscreen-size-y |
| |
| unevaluatedProperties: false |
| |
| examples: |
| - | |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/interrupt-controller/irq.h> |
| |
| spi { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| touchscreen@0 { |
| compatible = "apple,j293-touchbar"; |
| reg = <0>; |
| spi-max-frequency = <11500000>; |
| reset-gpios = <&pinctrl_ap 139 GPIO_ACTIVE_LOW>; |
| interrupts-extended = <&pinctrl_ap 194 IRQ_TYPE_EDGE_FALLING>; |
| firmware-name = "apple/dfrmtfw-j293.bin"; |
| touchscreen-size-x = <23045>; |
| touchscreen-size-y = <640>; |
| }; |
| }; |
| |
| ... |
