| # SPDX-License-Identifier: GPL-2.0-only |
| # |
| # Phy drivers for STMicro platforms |
| # |
| config PHY_MIPHY28LP |
| tristate "STMicroelectronics MIPHY28LP PHY driver for STiH407" |
| depends on ARCH_STI |
| select GENERIC_PHY |
| help |
| Enable this to support the miphy transceiver (for SATA/PCIE/USB3) |
| that is part of STMicroelectronics STiH407 SoC. |
| |
| config PHY_ST_SPEAR1310_MIPHY |
| tristate "ST SPEAR1310-MIPHY driver" |
| select GENERIC_PHY |
| depends on MACH_SPEAR1310 || COMPILE_TEST |
| help |
| Support for ST SPEAr1310 MIPHY which can be used for PCIe and SATA. |
| |
| config PHY_ST_SPEAR1340_MIPHY |
| tristate "ST SPEAR1340-MIPHY driver" |
| select GENERIC_PHY |
| depends on MACH_SPEAR1340 || COMPILE_TEST |
| help |
| Support for ST SPEAr1340 MIPHY which can be used for PCIe and SATA. |
| |
| config PHY_STIH407_USB |
| tristate "STMicroelectronics USB2 picoPHY driver for STiH407 family" |
| depends on RESET_CONTROLLER |
| depends on ARCH_STI || COMPILE_TEST |
| select GENERIC_PHY |
| help |
| Enable this support to enable the picoPHY device used by USB2 |
| and USB3 controllers on STMicroelectronics STiH407 SoC families. |
| |
| config PHY_STM32_USBPHYC |
| tristate "STMicroelectronics STM32 USB HS PHY Controller driver" |
| depends on ARCH_STM32 || COMPILE_TEST |
| depends on COMMON_CLK |
| select GENERIC_PHY |
| help |
| Enable this to support the High-Speed USB transceivers that are part |
| of some STMicroelectronics STM32 SoCs. |
| |
| This driver controls the entire USB PHY block: the USB PHY controller |
| (USBPHYC) and the two 8-bit wide UTMI+ interfaces. First interface is |
| used by an HS USB Host controller, and the second one is shared |
| between an HS USB OTG controller and an HS USB Host controller, |
| selected by a USB switch. |
