Documentation/networking/devlink/ptp_ocp.rst

.. SPDX-License-Identifier: GPL-2.0

========================
ptp_ocp devlink support
========================

This document describes the devlink features implemented by the ``ptp_ocp``
device driver: the info versions it reports and its flash update support.

Info versions
=============

The ``ptp_ocp`` driver reports the following versions

.. list-table:: devlink info versions implemented
   :widths: 5 5 90

   * - Name
     - Type
     - Description
   * - ``fw``
     - running
     - Version of the firmware running on the card.  Reported as ``loader``
       instead when the card is running the firmware loader.
   * - ``board.id``
     - fixed
     - Board identifier, read from the on-card EEPROM.
   * - ``cpld.id``
     - fixed
     - Lattice device ID (IDCODE) of the TAP CPLD, formatted as ``0x%08x``.
       Only present on ADVA TimeCard X1 boards, which are the only ones
       carrying that CPLD.  Reading it claims the shared I2C bus and
       reprograms the on-card mux, so the driver does that from its own
       worker and reports the cached value here; the version is omitted
       until that read has succeeded.  The read is made once per binding
       and again after a successful CPLD update.
   * - ``fw.cpld``
     - running
     - USERCODE of the image programmed into the TAP CPLD, formatted as
       ``0x%08x``.  Read together with ``cpld.id`` and reported the same
       way.  This is the component name to pass to ``devlink dev flash``
       to update the CPLD.

Flash update
============

The driver implements ``devlink dev flash`` for two separate targets,
selected with the component name.

.. list-table:: Flash components
   :widths: 20 80

   * - Component
     - Description
   * - (none)
     - The card's own flash, written through the SPI controller the driver
       exposes.  The card runs the new image after its next reset.
   * - ``fw.cpld``
     - The configuration flash of the TAP CPLD on ADVA TimeCard X1 boards,
       programmed over I2C with the MachXO3 in-system programming commands
       and activated with a REFRESH, so the new image runs immediately.
       The image is the raw configuration bitstream.  The only check the
       driver makes is that its length is a non-zero multiple of the
       16-byte page size, so a container such as ``.jed`` has to be
       converted first rather than passed through - one whose length
       happens to be a multiple of 16 would be programmed as if it were
       a bitstream.

Programming the CPLD claims the shared I2C bus for the whole cycle, so
reads of the card's EEPROM block until it completes.  Progress is reported
with the standard devlink status notifications.

Example::

    $ devlink dev flash pci/0000:02:00.0 file adva-cpld.bin component fw.cpld