| menu "Sandbox architecture" | |
| depends on SANDBOX | |
| config SYS_ARCH | |
| default "sandbox" | |
| config SYS_BOARD | |
| default "sandbox" | |
| config SYS_CPU | |
| default "sandbox" | |
| config SANDBOX64 | |
| bool "Use 64-bit addresses" | |
| select PHYS_64BIT | |
| depends on HOST_64BIT | |
| config SANDBOX_RAM_SIZE_MB | |
| int "RAM size in MiB" | |
| default 256 | |
| range 64 4095 if !SANDBOX64 | |
| range 64 268435456 if SANDBOX64 | |
| help | |
| Memory size of the sandbox in MiB. The default value is 256 MiB. | |
| The minimum value is 64 MiB. The maximum value is 4095 MiB for the | |
| 32bit sandbox. | |
| config SANDBOX_SPL | |
| bool "Enable SPL for sandbox" | |
| select SUPPORT_SPL | |
| config SANDBOX_TPL | |
| bool "Enable TPL for sandbox" | |
| select SUPPORT_TPL | |
| config SANDBOX_VPL | |
| bool "Enable VPL for sandbox" | |
| select SUPPORT_VPL | |
| config SYS_CONFIG_NAME | |
| default "sandbox_spl" if SANDBOX_SPL | |
| default "sandbox" if !SANDBOX_SPL | |
| config HOST_32BIT | |
| def_bool ! $(cc-define,_LP64) | |
| config HOST_64BIT | |
| def_bool $(cc-define,_LP64) | |
| config HOST_HAS_SDL | |
| def_bool $(success,sdl2-config --version) | |
| config SANDBOX_SDL | |
| bool "Enable SDL2 support in sandbox" | |
| default HOST_HAS_SDL | |
| config SANDBOX_CRASH_RESET | |
| bool "Reset on crash" | |
| help | |
| If an illegal instruction or an illegal memory access occurs, the | |
| sandbox exits with an error by default. | |
| If the u-boot binary is invoked with --signals (or -S), U-Boot will | |
| handle the signal writing a crash dump before exiting. | |
| If you additionally set the CONFIG_SANDBOX_CRASH_RESET flag, the | |
| sandbox is reset after writing the crash dump. This may be useful | |
| when running test suites like the UEFI self certification test which | |
| continue with the next test after a crash. | |
| config SANDBOX_BITS_PER_LONG | |
| int | |
| default 32 if HOST_32BIT | |
| default 64 if HOST_64BIT | |
| config SYS_FDT_LOAD_ADDR | |
| hex "Address at which to load devicetree" | |
| default 0x100 | |
| help | |
| With sandbox the devicetree is loaded into the emulated RAM. This sets | |
| the address that is used. There must be enough space at this address | |
| to load the full devicetree without it overwriting anything else. | |
| See `doc/arch/sandbox.rst` for more information. | |
| endmenu | |
| config FWU_NUM_BANKS | |
| default 2 | |
| config FWU_NUM_IMAGES_PER_BANK | |
| default 2 |