| // SPDX-License-Identifier: GPL-2.0+ | |
| /* | |
| * (C) Copyright 2003 | |
| * Steven Scholz, imc Measurement & Control, steven.scholz@imc-berlin.de | |
| * | |
| * (C) Copyright 2002 | |
| * Rich Ireland, Enterasys Networks, rireland@enterasys.com. | |
| */ | |
| #define LOG_CATEGORY UCLASS_FPGA | |
| #include <config.h> /* core U-Boot definitions */ | |
| #include <console.h> | |
| #include <log.h> | |
| #include <ACEX1K.h> /* ACEX device family */ | |
| #include <linux/delay.h> | |
| /* Note: The assumption is that we cannot possibly run fast enough to | |
| * overrun the device (the Slave Parallel mode can free run at 50MHz). | |
| * If there is a need to operate slower, define CFG_FPGA_DELAY in | |
| * the board config file to slow things down. | |
| */ | |
| #ifndef CFG_FPGA_DELAY | |
| #define CFG_FPGA_DELAY() | |
| #endif | |
| #ifndef CFG_SYS_FPGA_WAIT | |
| #define CFG_SYS_FPGA_WAIT CONFIG_SYS_HZ/10 /* 100 ms */ | |
| #endif | |
| static int ACEX1K_ps_load(Altera_desc *desc, const void *buf, size_t bsize); | |
| static int ACEX1K_ps_dump(Altera_desc *desc, const void *buf, size_t bsize); | |
| /* static int ACEX1K_ps_info(Altera_desc *desc); */ | |
| /* ------------------------------------------------------------------------- */ | |
| /* ACEX1K Generic Implementation */ | |
| int ACEX1K_load(Altera_desc *desc, const void *buf, size_t bsize) | |
| { | |
| int ret_val = FPGA_FAIL; | |
| switch (desc->iface) { | |
| case passive_serial: | |
| log_debug("Launching Passive Serial Loader\n"); | |
| ret_val = ACEX1K_ps_load (desc, buf, bsize); | |
| break; | |
| /* Add new interface types here */ | |
| default: | |
| printf ("%s: Unsupported interface type, %d\n", | |
| __FUNCTION__, desc->iface); | |
| } | |
| return ret_val; | |
| } | |
| int ACEX1K_dump(Altera_desc *desc, const void *buf, size_t bsize) | |
| { | |
| int ret_val = FPGA_FAIL; | |
| switch (desc->iface) { | |
| case passive_serial: | |
| log_debug("Launching Passive Serial Dump\n"); | |
| ret_val = ACEX1K_ps_dump (desc, buf, bsize); | |
| break; | |
| /* Add new interface types here */ | |
| default: | |
| printf ("%s: Unsupported interface type, %d\n", | |
| __FUNCTION__, desc->iface); | |
| } | |
| return ret_val; | |
| } | |
| int ACEX1K_info( Altera_desc *desc ) | |
| { | |
| return FPGA_SUCCESS; | |
| } | |
| /* ------------------------------------------------------------------------- */ | |
| /* ACEX1K Passive Serial Generic Implementation */ | |
| static int ACEX1K_ps_load(Altera_desc *desc, const void *buf, size_t bsize) | |
| { | |
| int ret_val = FPGA_FAIL; /* assume the worst */ | |
| Altera_ACEX1K_Passive_Serial_fns *fn = desc->iface_fns; | |
| int i; | |
| log_debug("start with interface functions @ 0x%p\n", fn); | |
| if (fn) { | |
| size_t bytecount = 0; | |
| unsigned char *data = (unsigned char *) buf; | |
| int cookie = desc->cookie; /* make a local copy */ | |
| unsigned long ts; /* timestamp */ | |
| log_debug("Function Table:\n" | |
| "ptr:\t0x%p\n" | |
| "struct: 0x%p\n" | |
| "config:\t0x%p\n" | |
| "status:\t0x%p\n" | |
| "clk:\t0x%p\n" | |
| "data:\t0x%p\n" | |
| "done:\t0x%p\n\n", | |
| &fn, fn, fn->config, fn->status, | |
| fn->clk, fn->data, fn->done); | |
| #ifdef CONFIG_SYS_FPGA_PROG_FEEDBACK | |
| printf ("Loading FPGA Device %d...", cookie); | |
| #endif | |
| /* | |
| * Run the pre configuration function if there is one. | |
| */ | |
| if (*fn->pre) { | |
| (*fn->pre) (cookie); | |
| } | |
| /* Establish the initial state */ | |
| (*fn->config) (true, true, cookie); /* Assert nCONFIG */ | |
| udelay(2); /* T_cfg > 2us */ | |
| /* nSTATUS should be asserted now */ | |
| (*fn->done) (cookie); | |
| if ( !(*fn->status) (cookie) ) { | |
| puts ("** nSTATUS is not asserted.\n"); | |
| (*fn->abort) (cookie); | |
| return FPGA_FAIL; | |
| } | |
| (*fn->config) (false, true, cookie); /* Deassert nCONFIG */ | |
| udelay(2); /* T_cf2st1 < 4us */ | |
| /* Wait for nSTATUS to be released (i.e. deasserted) */ | |
| ts = get_timer (0); /* get current time */ | |
| do { | |
| CFG_FPGA_DELAY (); | |
| if (get_timer (ts) > CFG_SYS_FPGA_WAIT) { /* check the time */ | |
| puts ("** Timeout waiting for STATUS to go high.\n"); | |
| (*fn->abort) (cookie); | |
| return FPGA_FAIL; | |
| } | |
| (*fn->done) (cookie); | |
| } while ((*fn->status) (cookie)); | |
| /* Get ready for the burn */ | |
| CFG_FPGA_DELAY (); | |
| /* Load the data */ | |
| while (bytecount < bsize) { | |
| unsigned char val=0; | |
| #ifdef CONFIG_SYS_FPGA_CHECK_CTRLC | |
| if (ctrlc ()) { | |
| (*fn->abort) (cookie); | |
| return FPGA_FAIL; | |
| } | |
| #endif | |
| /* Altera detects an error if INIT goes low (active) | |
| while DONE is low (inactive) */ | |
| #if 0 /* not yet implemented */ | |
| if ((*fn->done) (cookie) == 0 && (*fn->init) (cookie)) { | |
| puts ("** CRC error during FPGA load.\n"); | |
| (*fn->abort) (cookie); | |
| return (FPGA_FAIL); | |
| } | |
| #endif | |
| val = data [bytecount ++ ]; | |
| i = 8; | |
| do { | |
| /* Deassert the clock */ | |
| (*fn->clk) (false, true, cookie); | |
| CFG_FPGA_DELAY (); | |
| /* Write data */ | |
| (*fn->data) ((val & 0x01), true, cookie); | |
| CFG_FPGA_DELAY (); | |
| /* Assert the clock */ | |
| (*fn->clk) (true, true, cookie); | |
| CFG_FPGA_DELAY (); | |
| val >>= 1; | |
| i --; | |
| } while (i > 0); | |
| #ifdef CONFIG_SYS_FPGA_PROG_FEEDBACK | |
| if (bytecount % (bsize / 40) == 0) | |
| putc ('.'); /* let them know we are alive */ | |
| #endif | |
| } | |
| CFG_FPGA_DELAY (); | |
| #ifdef CONFIG_SYS_FPGA_PROG_FEEDBACK | |
| putc (' '); /* terminate the dotted line */ | |
| #endif | |
| /* | |
| * Checking FPGA's CONF_DONE signal - correctly booted ? | |
| */ | |
| if ( ! (*fn->done) (cookie) ) { | |
| puts ("** Booting failed! CONF_DONE is still deasserted.\n"); | |
| (*fn->abort) (cookie); | |
| return (FPGA_FAIL); | |
| } | |
| /* | |
| * "DCLK must be clocked an additional 10 times fpr ACEX 1K..." | |
| */ | |
| for (i = 0; i < 12; i++) { | |
| CFG_FPGA_DELAY (); | |
| (*fn->clk) (true, true, cookie); /* Assert the clock pin */ | |
| CFG_FPGA_DELAY (); | |
| (*fn->clk) (false, true, cookie); /* Deassert the clock pin */ | |
| } | |
| ret_val = FPGA_SUCCESS; | |
| #ifdef CONFIG_SYS_FPGA_PROG_FEEDBACK | |
| if (ret_val == FPGA_SUCCESS) { | |
| puts ("Done.\n"); | |
| } | |
| else { | |
| puts ("Fail.\n"); | |
| } | |
| #endif | |
| (*fn->post) (cookie); | |
| } else { | |
| printf ("%s: NULL Interface function table!\n", __FUNCTION__); | |
| } | |
| return ret_val; | |
| } | |
| static int ACEX1K_ps_dump(Altera_desc *desc, const void *buf, size_t bsize) | |
| { | |
| /* Readback is only available through the Slave Parallel and */ | |
| /* boundary-scan interfaces. */ | |
| printf ("%s: Passive Serial Dumping is unavailable\n", | |
| __FUNCTION__); | |
| return FPGA_FAIL; | |
| } |