| /* SPDX-License-Identifier: GPL-2.0+ */ | |
| /* | |
| * (C) Copyright 2005, Psyent Corporation <www.psyent.com> | |
| * Scott McNutt <smcnutt@psyent.com> | |
| * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw> | |
| */ | |
| #ifndef __CONFIG_H | |
| #define __CONFIG_H | |
| /* | |
| * BOARD/CPU | |
| */ | |
| /* | |
| * SERIAL | |
| */ | |
| /* | |
| * CFI Flash | |
| */ | |
| #define CONFIG_SYS_CFI_FLASH_STATUS_POLL /* fix amd flash issue */ | |
| #define CONFIG_SYS_MAX_FLASH_BANKS_DETECT 1 | |
| #define CONFIG_SYS_MAX_FLASH_SECT 512 | |
| /* | |
| * NET options | |
| */ | |
| #define CONFIG_SYS_RX_ETH_BUFFER 0 | |
| #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN | |
| /* | |
| * BOOTP options | |
| */ | |
| #define CONFIG_BOOTP_BOOTFILESIZE | |
| /* | |
| * MEMORY ORGANIZATION | |
| * -Monitor at top of sdram. | |
| * -The heap is placed below the monitor | |
| * -The stack is placed below the heap (&grows down). | |
| */ | |
| #define CONFIG_SYS_SDRAM_BASE 0xD0000000 | |
| #define CONFIG_SYS_SDRAM_SIZE 0x08000000 | |
| #define CONFIG_MONITOR_IS_IN_RAM | |
| #define CONFIG_SYS_MONITOR_LEN 0x80000 /* Reserve 512k */ | |
| #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \ | |
| CONFIG_SYS_SDRAM_SIZE - \ | |
| CONFIG_SYS_MONITOR_LEN) | |
| #define CONFIG_SYS_MALLOC_LEN 0x20000 | |
| /* | |
| * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above | |
| * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the | |
| * reset address, no? This will keep the environment in user region | |
| * of flash. NOTE: the monitor length must be multiple of sector size | |
| * (which is common practice). | |
| */ | |
| /* | |
| * MISC | |
| */ | |
| #define CONFIG_SYS_LOAD_ADDR 0xd4000000 /* Half of RAM */ | |
| #define CONFIG_LOADADDR CONFIG_SYS_LOAD_ADDR | |
| #endif /* __CONFIG_H */ |