| // SPDX-License-Identifier: GPL-2.0+ | |
| /* | |
| * Copyright (C) 2011 OMICRON electronics GmbH | |
| * | |
| * based on drivers/mtd/nand/raw/nand_spl_load.c | |
| * | |
| * Copyright (C) 2011 | |
| * Heiko Schocher, DENX Software Engineering, hs@denx.de. | |
| */ | |
| #include <common.h> | |
| #include <image.h> | |
| #include <log.h> | |
| #include <spi.h> | |
| #include <spi_flash.h> | |
| #include <errno.h> | |
| #include <spl.h> | |
| #include <asm/global_data.h> | |
| #include <dm/ofnode.h> | |
| #if CONFIG_IS_ENABLED(OS_BOOT) | |
| /* | |
| * Load the kernel, check for a valid header we can parse, and if found load | |
| * the kernel and then device tree. | |
| */ | |
| static int spi_load_image_os(struct spl_image_info *spl_image, | |
| struct spl_boot_device *bootdev, | |
| struct spi_flash *flash, | |
| struct legacy_img_hdr *header) | |
| { | |
| int err; | |
| /* Read for a header, parse or error out. */ | |
| spi_flash_read(flash, CONFIG_SYS_SPI_KERNEL_OFFS, sizeof(*header), | |
| (void *)header); | |
| if (image_get_magic(header) != IH_MAGIC) | |
| return -1; | |
| err = spl_parse_image_header(spl_image, bootdev, header); | |
| if (err) | |
| return err; | |
| spi_flash_read(flash, CONFIG_SYS_SPI_KERNEL_OFFS, | |
| spl_image->size, (void *)spl_image->load_addr); | |
| /* Read device tree. */ | |
| spi_flash_read(flash, CONFIG_SYS_SPI_ARGS_OFFS, | |
| CONFIG_SYS_SPI_ARGS_SIZE, | |
| (void *)CONFIG_SYS_SPL_ARGS_ADDR); | |
| return 0; | |
| } | |
| #endif | |
| static ulong spl_spi_fit_read(struct spl_load_info *load, ulong sector, | |
| ulong count, void *buf) | |
| { | |
| struct spi_flash *flash = load->dev; | |
| ulong ret; | |
| ret = spi_flash_read(flash, sector, count, buf); | |
| if (!ret) | |
| return count; | |
| else | |
| return 0; | |
| } | |
| unsigned int __weak spl_spi_get_uboot_offs(struct spi_flash *flash) | |
| { | |
| return CONFIG_SYS_SPI_U_BOOT_OFFS; | |
| } | |
| u32 __weak spl_spi_boot_bus(void) | |
| { | |
| return CONFIG_SF_DEFAULT_BUS; | |
| } | |
| u32 __weak spl_spi_boot_cs(void) | |
| { | |
| return CONFIG_SF_DEFAULT_CS; | |
| } | |
| /* | |
| * The main entry for SPI booting. It's necessary that SDRAM is already | |
| * configured and available since this code loads the main U-Boot image | |
| * from SPI into SDRAM and starts it from there. | |
| */ | |
| static int spl_spi_load_image(struct spl_image_info *spl_image, | |
| struct spl_boot_device *bootdev) | |
| { | |
| int err = 0; | |
| unsigned int payload_offs; | |
| struct spi_flash *flash; | |
| struct legacy_img_hdr *header; | |
| unsigned int sf_bus = spl_spi_boot_bus(); | |
| unsigned int sf_cs = spl_spi_boot_cs(); | |
| /* | |
| * Load U-Boot image from SPI flash into RAM | |
| * In DM mode: defaults speed and mode will be | |
| * taken from DT when available | |
| */ | |
| flash = spi_flash_probe(sf_bus, sf_cs, | |
| CONFIG_SF_DEFAULT_SPEED, | |
| CONFIG_SF_DEFAULT_MODE); | |
| if (!flash) { | |
| puts("SPI probe failed.\n"); | |
| return -ENODEV; | |
| } | |
| payload_offs = spl_spi_get_uboot_offs(flash); | |
| header = spl_get_load_buffer(-sizeof(*header), sizeof(*header)); | |
| if (CONFIG_IS_ENABLED(OF_REAL)) { | |
| payload_offs = ofnode_conf_read_int("u-boot,spl-payload-offset", | |
| payload_offs); | |
| } | |
| #if CONFIG_IS_ENABLED(OS_BOOT) | |
| if (spl_start_uboot() || spi_load_image_os(spl_image, bootdev, flash, header)) | |
| #endif | |
| { | |
| /* Load u-boot, mkimage header is 64 bytes. */ | |
| err = spi_flash_read(flash, payload_offs, sizeof(*header), | |
| (void *)header); | |
| if (err) { | |
| debug("%s: Failed to read from SPI flash (err=%d)\n", | |
| __func__, err); | |
| return err; | |
| } | |
| if (IS_ENABLED(CONFIG_SPL_LOAD_FIT_FULL) && | |
| image_get_magic(header) == FDT_MAGIC) { | |
| err = spi_flash_read(flash, payload_offs, | |
| roundup(fdt_totalsize(header), 4), | |
| (void *)CONFIG_SYS_LOAD_ADDR); | |
| if (err) | |
| return err; | |
| err = spl_parse_image_header(spl_image, bootdev, | |
| (struct legacy_img_hdr *)CONFIG_SYS_LOAD_ADDR); | |
| } else if (IS_ENABLED(CONFIG_SPL_LOAD_FIT) && | |
| image_get_magic(header) == FDT_MAGIC) { | |
| struct spl_load_info load; | |
| debug("Found FIT\n"); | |
| load.dev = flash; | |
| load.priv = NULL; | |
| load.filename = NULL; | |
| load.bl_len = 1; | |
| load.read = spl_spi_fit_read; | |
| err = spl_load_simple_fit(spl_image, &load, | |
| payload_offs, | |
| header); | |
| } else if (IS_ENABLED(CONFIG_SPL_LOAD_IMX_CONTAINER)) { | |
| struct spl_load_info load; | |
| load.dev = flash; | |
| load.priv = NULL; | |
| load.filename = NULL; | |
| load.bl_len = 1; | |
| load.read = spl_spi_fit_read; | |
| err = spl_load_imx_container(spl_image, &load, | |
| payload_offs); | |
| } else { | |
| err = spl_parse_image_header(spl_image, bootdev, header); | |
| if (err) | |
| return err; | |
| err = spi_flash_read(flash, payload_offs + spl_image->offset, | |
| spl_image->size, | |
| (void *)spl_image->load_addr); | |
| } | |
| if (IS_ENABLED(CONFIG_SPI_FLASH_SOFT_RESET)) { | |
| err = spi_nor_remove(flash); | |
| if (err) | |
| return err; | |
| } | |
| } | |
| return err; | |
| } | |
| /* Use priorty 1 so that boards can override this */ | |
| SPL_LOAD_IMAGE_METHOD("SPI", 1, BOOT_DEVICE_SPI, spl_spi_load_image); |