| /* | |
| * Copyright 2016 Freescale Semiconductor | |
| * | |
| * SPDX-License-Identifier: GPL-2.0+ | |
| */ | |
| #ifndef __LS1012A_COMMON_H | |
| #define __LS1012A_COMMON_H | |
| #define CONFIG_FSL_LAYERSCAPE | |
| #define CONFIG_GICV2 | |
| #include <asm/arch/config.h> | |
| #include <asm/arch/stream_id_lsch2.h> | |
| #define CONFIG_SUPPORT_RAW_INITRD | |
| #define CONFIG_DISPLAY_BOARDINFO_LATE | |
| #define CONFIG_SYS_TEXT_BASE 0x40100000 | |
| #define CONFIG_SYS_CLK_FREQ 125000000 | |
| #define CONFIG_SKIP_LOWLEVEL_INIT | |
| #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0) | |
| #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000) | |
| #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000 | |
| #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0 | |
| #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE | |
| #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL | |
| /* Generic Timer Definitions */ | |
| #define COUNTER_FREQUENCY 25000000 /* 25MHz */ | |
| /* CSU */ | |
| #define CONFIG_LAYERSCAPE_NS_ACCESS | |
| /* Size of malloc() pool */ | |
| #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024) | |
| /*SPI device */ | |
| #ifdef CONFIG_QSPI_BOOT | |
| #define CONFIG_SYS_QE_FW_IN_SPIFLASH | |
| #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000 | |
| #define CONFIG_ENV_SPI_BUS 0 | |
| #define CONFIG_ENV_SPI_CS 0 | |
| #define CONFIG_ENV_SPI_MAX_HZ 1000000 | |
| #define CONFIG_ENV_SPI_MODE 0x03 | |
| #define CONFIG_SPI_FLASH_SPANSION | |
| #define CONFIG_FSL_SPI_INTERFACE | |
| #define CONFIG_SF_DATAFLASH | |
| #define CONFIG_FSL_QSPI | |
| #define QSPI0_AMBA_BASE 0x40000000 | |
| #define CONFIG_SPI_FLASH_SPANSION | |
| #define FSL_QSPI_FLASH_SIZE SZ_64M | |
| #define FSL_QSPI_FLASH_NUM 2 | |
| /* | |
| * Environment | |
| */ | |
| #define CONFIG_ENV_OVERWRITE | |
| #define CONFIG_ENV_SIZE 0x40000 /* 256KB */ | |
| #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */ | |
| #define CONFIG_ENV_SECT_SIZE 0x40000 | |
| #endif | |
| /* I2C */ | |
| #define CONFIG_SYS_I2C | |
| #define CONFIG_SYS_I2C_MXC | |
| #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */ | |
| #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */ | |
| #define CONFIG_CONS_INDEX 1 | |
| #define CONFIG_SYS_NS16550_SERIAL | |
| #define CONFIG_SYS_NS16550_REG_SIZE 1 | |
| #define CONFIG_SYS_NS16550_CLK (get_serial_clock()) | |
| #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } | |
| #define CONFIG_SYS_HZ 1000 | |
| #define CONFIG_HWCONFIG | |
| #define HWCONFIG_BUFFER_SIZE 128 | |
| #include <config_distro_defaults.h> | |
| #ifndef CONFIG_SPL_BUILD | |
| #define BOOT_TARGET_DEVICES(func) \ | |
| func(MMC, mmc, 0) \ | |
| func(USB, usb, 0) | |
| #include <config_distro_bootcmd.h> | |
| #endif | |
| /* Initial environment variables */ | |
| #define CONFIG_EXTRA_ENV_SETTINGS \ | |
| "verify=no\0" \ | |
| "loadaddr=0x80100000\0" \ | |
| "kernel_addr=0x100000\0" \ | |
| "fdt_high=0xffffffffffffffff\0" \ | |
| "initrd_high=0xffffffffffffffff\0" \ | |
| "kernel_start=0x1000000\0" \ | |
| "kernel_load=0xa0000000\0" \ | |
| "kernel_size=0x2800000\0" \ | |
| #undef CONFIG_BOOTCOMMAND | |
| #define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\ | |
| "$kernel_start $kernel_size && "\ | |
| "bootm $kernel_load" | |
| /* Monitor Command Prompt */ | |
| #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */ | |
| #define CONFIG_SYS_LONGHELP | |
| #define CONFIG_AUTO_COMPLETE | |
| #define CONFIG_SYS_MAXARGS 64 /* max command args */ | |
| #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */ | |
| #include <asm/arch/soc.h> | |
| #endif /* __LS1012A_COMMON_H */ |