| CONFIG_PPC=y | |
| CONFIG_TEXT_BASE=0x11000000 | |
| CONFIG_SYS_MALLOC_LEN=0x100000 | |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y | |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y | |
| CONFIG_SF_DEFAULT_SPEED=10000000 | |
| CONFIG_ENV_SIZE=0x2000 | |
| CONFIG_ENV_OFFSET=0x0 | |
| CONFIG_DEFAULT_DEVICE_TREE="p1010rdb-pb_36b" | |
| CONFIG_SYS_MONITOR_LEN=786432 | |
| CONFIG_SPL_MMC=y | |
| CONFIG_SPL_SERIAL=y | |
| CONFIG_SPL_DRIVERS_MISC=y | |
| CONFIG_SPL_TEXT_BASE=0xD0000000 | |
| CONFIG_SPL=y | |
| CONFIG_MPC85xx=y | |
| CONFIG_SYS_INIT_RAM_LOCK=y | |
| CONFIG_TARGET_P1010RDB_PB=y | |
| CONFIG_L2_CACHE=y | |
| CONFIG_ENABLE_36BIT_PHYS=y | |
| CONFIG_SYS_MPC85XX_NO_RESETVEC=y | |
| CONFIG_SPL_SYS_MPC85XX_NO_RESETVEC=y | |
| CONFIG_USE_UBOOTPATH=y | |
| CONFIG_PCIE1=y | |
| CONFIG_PCIE2=y | |
| CONFIG_PHYS_64BIT=y | |
| CONFIG_FIT=y | |
| CONFIG_FIT_VERBOSE=y | |
| CONFIG_FSL_FIXED_MMC_LOCATION=y | |
| CONFIG_BOOTDELAY=10 | |
| CONFIG_OF_BOARD_SETUP=y | |
| CONFIG_OF_STDOUT_VIA_ALIAS=y | |
| CONFIG_USE_BOOTCOMMAND=y | |
| CONFIG_BOOTCOMMAND="setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate $othbootargs ramdisk_size=$ramdisk_size;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr $ramdiskaddr $fdtaddr" | |
| CONFIG_SYS_PBSIZE=276 | |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y | |
| CONFIG_BOARD_EARLY_INIT_F=y | |
| CONFIG_BOARD_EARLY_INIT_R=y | |
| CONFIG_ID_EEPROM=y | |
| # CONFIG_SPL_FRAMEWORK is not set | |
| CONFIG_SPL_MAX_SIZE=0x18000 | |
| CONFIG_SPL_MMC_BOOT=y | |
| CONFIG_SPL_SYS_CCSR_DO_NOT_RELOCATE=y | |
| CONFIG_SPL_FLUSH_IMAGE=y | |
| CONFIG_SPL_GD_ADDR=0xd0018000 | |
| CONFIG_SPL_RELOC_TEXT_BASE=0xd0000000 | |
| CONFIG_SPL_RELOC_STACK=0xd001c000 | |
| CONFIG_SPL_RELOC_MALLOC=y | |
| CONFIG_SPL_RELOC_MALLOC_ADDR=0xd0020000 | |
| CONFIG_SPL_RELOC_MALLOC_SIZE=0x20000 | |
| CONFIG_SPL_ENV_SUPPORT=y | |
| CONFIG_SPL_I2C=y | |
| CONFIG_SPL_MPC8XXX_INIT_DDR=y | |
| CONFIG_HUSH_PARSER=y | |
| CONFIG_CMD_IMLS=y | |
| CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3 | |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 | |
| CONFIG_CMD_I2C=y | |
| CONFIG_LOADS_ECHO=y | |
| CONFIG_SYS_LOADS_BAUD_CHANGE=y | |
| CONFIG_CMD_MMC=y | |
| CONFIG_CMD_USB=y | |
| CONFIG_CMD_MII=y | |
| CONFIG_CMD_PING=y | |
| CONFIG_CMD_EXT2=y | |
| CONFIG_CMD_FAT=y | |
| CONFIG_MTDIDS_DEFAULT="nand0=ff800000.flash" | |
| CONFIG_MTDPARTS_DEFAULT="mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)" | |
| CONFIG_OF_CONTROL=y | |
| CONFIG_ENV_OVERWRITE=y | |
| CONFIG_ENV_IS_IN_MMC=y | |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y | |
| CONFIG_USE_BOOTFILE=y | |
| CONFIG_BOOTFILE="uImage" | |
| CONFIG_USE_ETHPRIME=y | |
| CONFIG_ETHPRIME="eTSEC1" | |
| CONFIG_USE_ROOTPATH=y | |
| CONFIG_FSL_SATA_V2=y | |
| CONFIG_SYS_SATA_MAX_DEVICE=2 | |
| CONFIG_FSL_CAAM=y | |
| CONFIG_DDR_CLK_FREQ=66666666 | |
| CONFIG_SYS_SPD_BUS_NUM=1 | |
| CONFIG_CHIP_SELECTS_PER_CTRL=1 | |
| CONFIG_SYS_DDR_RAW_TIMING=y | |
| CONFIG_SPL_COMMON_INIT_DDR=y | |
| CONFIG_DM_I2C=y | |
| CONFIG_SPL_SYS_I2C_LEGACY=y | |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y | |
| CONFIG_SYS_I2C_FSL=y | |
| CONFIG_SYS_FSL_I2C_OFFSET=0x3000 | |
| CONFIG_SYS_FSL_HAS_I2C2_OFFSET=y | |
| CONFIG_SYS_FSL_I2C2_OFFSET=0x3100 | |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x57 | |
| CONFIG_FSL_ESDHC=y | |
| CONFIG_MTD=y | |
| CONFIG_MTD_NOR_FLASH=y | |
| CONFIG_FLASH_CFI_DRIVER=y | |
| CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y | |
| CONFIG_SYS_FLASH_EMPTY_INFO=y | |
| CONFIG_SYS_FLASH_CFI=y | |
| CONFIG_SYS_FLASH_QUIET_TEST=y | |
| CONFIG_SYS_MAX_FLASH_SECT=256 | |
| CONFIG_DM_SPI_FLASH=y | |
| CONFIG_SPI_FLASH_SPANSION=y | |
| CONFIG_PHY_ATHEROS=y | |
| CONFIG_PHY_BROADCOM=y | |
| CONFIG_PHY_DAVICOM=y | |
| CONFIG_PHY_LXT=y | |
| CONFIG_PHY_MARVELL=y | |
| CONFIG_PHY_NATSEMI=y | |
| CONFIG_PHY_REALTEK=y | |
| CONFIG_PHY_SMSC=y | |
| CONFIG_PHY_VITESSE=y | |
| CONFIG_DM_MDIO=y | |
| CONFIG_PHY_GIGE=y | |
| CONFIG_E1000=y | |
| CONFIG_MII=y | |
| CONFIG_TSEC_ENET=y | |
| CONFIG_PCIE_FSL=y | |
| CONFIG_DM_RTC=y | |
| CONFIG_RTC_PT7C4338=y | |
| CONFIG_SYS_NS16550_SERIAL=y | |
| CONFIG_SPI=y | |
| CONFIG_DM_SPI=y | |
| CONFIG_FSL_ESPI=y | |
| CONFIG_USB=y | |
| CONFIG_USB_EHCI_FSL=y | |
| CONFIG_ADDR_MAP=y |