| CONFIG_ARM=y | |
| CONFIG_ARCH_AT91=y | |
| CONFIG_TARGET_AT91SAM9260EK=y | |
| CONFIG_SYS_MALLOC_F_LEN=0x2000 | |
| CONFIG_DEFAULT_DEVICE_TREE="at91sam9g20ek" | |
| CONFIG_DEBUG_UART=y | |
| CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9G20,SYS_USE_DATAFLASH_CS0" | |
| CONFIG_ENV_IS_IN_SPI_FLASH=y | |
| CONFIG_BOOTDELAY=3 | |
| CONFIG_USE_BOOTARGS=y | |
| CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/mtdblock0 mtdparts=atmel_nand:-(root) rw rootfstype=jffs2" | |
| # CONFIG_DISPLAY_BOARDINFO is not set | |
| CONFIG_SYS_PROMPT="U-Boot> " | |
| # CONFIG_CMD_BDI is not set | |
| CONFIG_CMD_BOOTZ=y | |
| # CONFIG_CMD_IMI is not set | |
| # CONFIG_CMD_IMLS is not set | |
| # CONFIG_CMD_FPGA is not set | |
| # CONFIG_CMD_LOADS is not set | |
| CONFIG_CMD_NAND=y | |
| CONFIG_CMD_SF=y | |
| CONFIG_CMD_USB=y | |
| # CONFIG_CMD_SOURCE is not set | |
| # CONFIG_CMD_SETEXPR is not set | |
| CONFIG_CMD_DHCP=y | |
| CONFIG_CMD_PING=y | |
| CONFIG_CMD_FAT=y | |
| CONFIG_OF_CONTROL=y | |
| CONFIG_DM=y | |
| CONFIG_CLK=y | |
| CONFIG_CLK_AT91=y | |
| CONFIG_DM_GPIO=y | |
| CONFIG_AT91_GPIO=y | |
| # CONFIG_MMC is not set | |
| CONFIG_DM_SPI_FLASH=y | |
| CONFIG_SPI_FLASH=y | |
| CONFIG_SPI_FLASH_ATMEL=y | |
| CONFIG_SPI_FLASH_DATAFLASH=y | |
| CONFIG_DM_ETH=y | |
| CONFIG_MACB=y | |
| CONFIG_PINCTRL=y | |
| CONFIG_PINCTRL_AT91=y | |
| CONFIG_DM_SERIAL=y | |
| CONFIG_DEBUG_UART_ATMEL=y | |
| CONFIG_DEBUG_UART_BASE=0xfffff200 | |
| CONFIG_DEBUG_UART_CLOCK=132000000 | |
| CONFIG_DEBUG_UART_BOARD_INIT=y | |
| CONFIG_DEBUG_UART_ANNOUNCE=y | |
| CONFIG_ATMEL_USART=y | |
| CONFIG_DM_SPI=y | |
| CONFIG_ATMEL_SPI=y | |
| CONFIG_USB=y | |
| CONFIG_USB_STORAGE=y |