| /* | |
| * (C) Copyright 2005, Psyent Corporation <www.psyent.com> | |
| * Scott McNutt <smcnutt@psyent.com> | |
| * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw> | |
| * | |
| * SPDX-License-Identifier: GPL-2.0+ | |
| */ | |
| #ifndef __CONFIG_H | |
| #define __CONFIG_H | |
| /* | |
| * BOARD/CPU | |
| */ | |
| #define CONFIG_DISPLAY_BOARDINFO_LATE | |
| /* | |
| * SERIAL | |
| */ | |
| /* | |
| * CFI Flash | |
| */ | |
| #define CONFIG_FLASH_CFI_DRIVER | |
| #define CONFIG_SYS_CFI_FLASH_STATUS_POLL /* fix amd flash issue */ | |
| #define CONFIG_SYS_FLASH_CFI | |
| #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE | |
| #define CONFIG_SYS_FLASH_PROTECTION | |
| #define CONFIG_SYS_MAX_FLASH_BANKS_DETECT 1 | |
| #define CONFIG_SYS_MAX_FLASH_SECT 512 | |
| /* | |
| * NET options | |
| */ | |
| #define CONFIG_SYS_RX_ETH_BUFFER 0 | |
| #define CONFIG_PHY_GIGE | |
| #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN | |
| #define CONFIG_PHY_MARVELL | |
| /* | |
| * BOOTP options | |
| */ | |
| #define CONFIG_BOOTP_BOOTFILESIZE | |
| #define CONFIG_BOOTP_BOOTPATH | |
| #define CONFIG_BOOTP_GATEWAY | |
| #define CONFIG_BOOTP_HOSTNAME | |
| /* | |
| * FDT options | |
| */ | |
| #define CONFIG_LMB | |
| /* | |
| * MEMORY ORGANIZATION | |
| * -Monitor at top of sdram. | |
| * -The heap is placed below the monitor | |
| * -The stack is placed below the heap (&grows down). | |
| */ | |
| #define CONFIG_SYS_SDRAM_BASE 0xD0000000 | |
| #define CONFIG_SYS_SDRAM_SIZE 0x08000000 | |
| #define CONFIG_NR_DRAM_BANKS 1 | |
| #define CONFIG_MONITOR_IS_IN_RAM | |
| #define CONFIG_SYS_MONITOR_LEN 0x80000 /* Reserve 512k */ | |
| #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \ | |
| CONFIG_SYS_SDRAM_SIZE - \ | |
| CONFIG_SYS_MONITOR_LEN) | |
| #define CONFIG_SYS_MALLOC_LEN 0x20000 | |
| /* | |
| * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above | |
| * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the | |
| * reset address, no? This will keep the environment in user region | |
| * of flash. NOTE: the monitor length must be multiple of sector size | |
| * (which is common practice). | |
| */ | |
| #define CONFIG_ENV_SIZE 0x20000 /* 128k, 1 sector */ | |
| #define CONFIG_ENV_OVERWRITE /* Serial change Ok */ | |
| #define CONFIG_ENV_ADDR (0xe2800000 + CONFIG_SYS_MONITOR_LEN) | |
| /* | |
| * MISC | |
| */ | |
| #define CONFIG_SYS_LONGHELP /* Provide extended help */ | |
| #define CONFIG_SYS_CBSIZE 256 /* Console I/O buf size */ | |
| #define CONFIG_SYS_MAXARGS 16 /* Max command args */ | |
| #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Bootarg buf size */ | |
| #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \ | |
| sizeof(CONFIG_SYS_PROMPT) + \ | |
| 16) /* Print buf size */ | |
| #define CONFIG_SYS_LOAD_ADDR 0xd4000000 /* Half of RAM */ | |
| #define CONFIG_LOADADDR CONFIG_SYS_LOAD_ADDR | |
| #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE | |
| #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MONITOR_BASE - \ | |
| CONFIG_ENV_SIZE - \ | |
| CONFIG_SYS_MALLOC_LEN - \ | |
| 0x10000) | |
| #define CONFIG_AUTO_COMPLETE | |
| #define CONFIG_CMDLINE_EDITING | |
| #endif /* __CONFIG_H */ |