| // SPDX-License-Identifier: GPL-2.0+ | |
| /* | |
| * Advanced Crypto Engine - SHA Firmware | |
| * Copyright (c) 2012 Samsung Electronics | |
| */ | |
| #include <config.h> | |
| #include "ace_sha.h" | |
| #include <log.h> | |
| #include <rand.h> | |
| #include <linux/string.h> | |
| #ifdef CONFIG_SHA_HW_ACCEL | |
| #include <u-boot/sha256.h> | |
| #include <u-boot/sha1.h> | |
| #include <linux/errno.h> | |
| /* SHA1 value for the message of zero length */ | |
| static const unsigned char sha1_digest_emptymsg[SHA1_SUM_LEN] = { | |
| 0xDA, 0x39, 0xA3, 0xEE, 0x5E, 0x6B, 0x4B, 0x0D, | |
| 0x32, 0x55, 0xBF, 0xFF, 0x95, 0x60, 0x18, 0x90, | |
| 0xAF, 0xD8, 0x07, 0x09}; | |
| /* SHA256 value for the message of zero length */ | |
| static const unsigned char sha256_digest_emptymsg[SHA256_SUM_LEN] = { | |
| 0xE3, 0xB0, 0xC4, 0x42, 0x98, 0xFC, 0x1C, 0x14, | |
| 0x9A, 0xFB, 0xF4, 0xC8, 0x99, 0x6F, 0xB9, 0x24, | |
| 0x27, 0xAE, 0x41, 0xE4, 0x64, 0x9B, 0x93, 0x4C, | |
| 0xA4, 0x95, 0x99, 0x1B, 0x78, 0x52, 0xB8, 0x55}; | |
| int ace_sha_hash_digest(const unsigned char *pbuf, unsigned int buf_len, | |
| unsigned char *pout, unsigned int hash_type) | |
| { | |
| unsigned int i, reg, len; | |
| unsigned int *pdigest; | |
| struct exynos_ace_sfr *ace_sha_reg = | |
| (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); | |
| if (buf_len == 0) { | |
| /* ACE H/W cannot compute hash value for empty string */ | |
| if (hash_type == ACE_SHA_TYPE_SHA1) | |
| memcpy(pout, sha1_digest_emptymsg, SHA1_SUM_LEN); | |
| else | |
| memcpy(pout, sha256_digest_emptymsg, SHA256_SUM_LEN); | |
| return 0; | |
| } | |
| /* Flush HRDMA */ | |
| writel(ACE_FC_HRDMACFLUSH_ON, &ace_sha_reg->fc_hrdmac); | |
| writel(ACE_FC_HRDMACFLUSH_OFF, &ace_sha_reg->fc_hrdmac); | |
| /* Set byte swap of data in */ | |
| writel(ACE_HASH_SWAPDI_ON | ACE_HASH_SWAPDO_ON | ACE_HASH_SWAPIV_ON, | |
| &ace_sha_reg->hash_byteswap); | |
| /* Select Hash input mux as external source */ | |
| reg = readl(&ace_sha_reg->fc_fifoctrl); | |
| reg = (reg & ~ACE_FC_SELHASH_MASK) | ACE_FC_SELHASH_EXOUT; | |
| writel(reg, &ace_sha_reg->fc_fifoctrl); | |
| /* Set Hash as SHA1 or SHA256 and start Hash engine */ | |
| reg = (hash_type == ACE_SHA_TYPE_SHA1) ? | |
| ACE_HASH_ENGSEL_SHA1HASH : ACE_HASH_ENGSEL_SHA256HASH; | |
| reg |= ACE_HASH_STARTBIT_ON; | |
| writel(reg, &ace_sha_reg->hash_control); | |
| /* Enable FIFO mode */ | |
| writel(ACE_HASH_FIFO_ON, &ace_sha_reg->hash_fifo_mode); | |
| /* Set message length */ | |
| writel(buf_len, &ace_sha_reg->hash_msgsize_low); | |
| writel(0, &ace_sha_reg->hash_msgsize_high); | |
| /* Set HRDMA */ | |
| writel((unsigned int)pbuf, &ace_sha_reg->fc_hrdmas); | |
| writel(buf_len, &ace_sha_reg->fc_hrdmal); | |
| while ((readl(&ace_sha_reg->hash_status) & ACE_HASH_MSGDONE_MASK) == | |
| ACE_HASH_MSGDONE_OFF) { | |
| /* | |
| * PRNG error bit goes HIGH if a PRNG request occurs without | |
| * a complete seed setup. We are using this bit to check h/w | |
| * fault because proper setup is not expected in that case. | |
| */ | |
| if ((readl(&ace_sha_reg->hash_status) | |
| & ACE_HASH_PRNGERROR_MASK) == ACE_HASH_PRNGERROR_ON) | |
| return -EBUSY; | |
| } | |
| /* Clear MSG_DONE bit */ | |
| writel(ACE_HASH_MSGDONE_ON, &ace_sha_reg->hash_status); | |
| /* Read hash result */ | |
| pdigest = (unsigned int *)pout; | |
| len = (hash_type == ACE_SHA_TYPE_SHA1) ? SHA1_SUM_LEN : SHA256_SUM_LEN; | |
| for (i = 0; i < len / 4; i++) | |
| pdigest[i] = readl(&ace_sha_reg->hash_result[i]); | |
| /* Clear HRDMA pending bit */ | |
| writel(ACE_FC_HRDMA, &ace_sha_reg->fc_intpend); | |
| return 0; | |
| } | |
| void hw_sha256(const unsigned char *pbuf, unsigned int buf_len, | |
| unsigned char *pout, unsigned int chunk_size) | |
| { | |
| if (ace_sha_hash_digest(pbuf, buf_len, pout, ACE_SHA_TYPE_SHA256)) | |
| debug("ACE was not setup properly or it is faulty\n"); | |
| } | |
| void hw_sha1(const unsigned char *pbuf, unsigned int buf_len, | |
| unsigned char *pout, unsigned int chunk_size) | |
| { | |
| if (ace_sha_hash_digest(pbuf, buf_len, pout, ACE_SHA_TYPE_SHA1)) | |
| debug("ACE was not setup properly or it is faulty\n"); | |
| } | |
| #endif /* CONFIG_SHA_HW_ACCEL */ | |
| #ifdef CONFIG_LIB_HW_RAND | |
| static unsigned int seed_done; | |
| void srand(unsigned int seed) | |
| { | |
| struct exynos_ace_sfr *reg = | |
| (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); | |
| int i, status; | |
| /* Seed data */ | |
| for (i = 0; i < ACE_HASH_PRNG_REG_NUM; i++) | |
| writel(seed << i, ®->hash_seed[i]); | |
| /* Wait for seed setup done */ | |
| while (1) { | |
| status = readl(®->hash_status); | |
| if ((status & ACE_HASH_SEEDSETTING_MASK) || | |
| (status & ACE_HASH_PRNGERROR_MASK)) | |
| break; | |
| } | |
| seed_done = 1; | |
| } | |
| unsigned int rand(void) | |
| { | |
| struct exynos_ace_sfr *reg = | |
| (struct exynos_ace_sfr *)samsung_get_base_ace_sfr(); | |
| int i, status; | |
| unsigned int seed = (unsigned int)&status; | |
| unsigned int ret = 0; | |
| if (!seed_done) | |
| srand(seed); | |
| /* Start PRNG */ | |
| writel(ACE_HASH_ENGSEL_PRNG | ACE_HASH_STARTBIT_ON, ®->hash_control); | |
| /* Wait for PRNG done */ | |
| while (1) { | |
| status = readl(®->hash_status); | |
| if (status & ACE_HASH_PRNGDONE_MASK) | |
| break; | |
| if (status & ACE_HASH_PRNGERROR_MASK) { | |
| seed_done = 0; | |
| return 0; | |
| } | |
| } | |
| /* Clear Done IRQ */ | |
| writel(ACE_HASH_PRNGDONE_MASK, ®->hash_status); | |
| /* Read a PRNG result */ | |
| for (i = 0; i < ACE_HASH_PRNG_REG_NUM; i++) | |
| ret += readl(®->hash_prng[i]); | |
| seed_done = 0; | |
| return ret; | |
| } | |
| unsigned int rand_r(unsigned int *seedp) | |
| { | |
| srand(*seedp); | |
| return rand(); | |
| } | |
| #endif /* CONFIG_LIB_HW_RAND */ |